K2000DVA Voice Announcers


Features

• Non-volatile memory (no batteries required)
• Stores up to eight 32-digit numbers (sixty four 32-digit numbers total)
• 8 minutes of record time (1 minute per input)
• Programmable message repeat counter
• Programmable lap counter
• Eight inputs programmable as normally open or normally closed and enabled or disabled
• Programmable ring delay for remote programming and alarm polling
• Programmable qualifier timer for each input (time for an event to be qualified as an alarm)
• Programmable resume timer for each input (time following reset for input to become active again)
• Call progress detection
• Programmable ringback limit for call progress
• Remote security and access codes
• Store caster mode
• Local or remote programming and recording
• RS-232 port for programming via a PC
• Compatible with the RC-2A and RC-3 remote DTMF controllers
• Made in the USA

Specifications

• Power: 120V AC/12V DC 500 mA, UL listed adapter provided
• Dimensions: 211mm x 160mm x 46mm (8.3” x 6.3” x 1.8”)
• Environmental: 0C to 32C (32F to 90F) with 5% to 95% noncondensing humidity
• Talk Battery: 12V DC
• Touch Tone Dialing: 120 ms on/off, 50 ms on/off
• CPC Detection Time: 320 ms minimum
• Message Record Time: 8 minutes
• Sampling Rate: 64 K (equivalent)
• Input Detection Time: 80 ms with Qualifier Timer set to 0
• Resolution Qualifier/Resume Timers: 1 second, with 18 hours maximum capacity
• Connections: (1) RJ11 jack for telco connection, (1) 3.5mm jack for 600-ohm audio output, (1) 9 pin RS-232 for connection to PC, (1) 12 position screw terminal block for inputs

K-2000-DVA Voice Announcers

Voice Alarm Dialing or Store Caster Announcements from up to Eight Inputs Viking s K-2000-DVA is a fully programmable multi-input, multinumber auto dialer and digital announcer, designed for emergency and non-emergency message notification. The K-2000- DVA has eight dry contact inputs, each of which can dial up to eight 32-digit phone numbers and play a message up to 1 minute in length specific to that input.
Messages can be recorded locally or remotely with a total message time for all 8 inputs of eight minutes. When configured as an alarm dialer, the K-2000-DVA has call progress detection capability with normal and fast busy, call pickup, CPC and ring-no-answer detection.
The K-2000-DVA can also be set up as a store caster (no dialing), for on-site promotional or assistance announcements.
Programming can be done with a Touch Tone phone or using a PC with a serial port connection and software available on the Viking website: http://www.vikingelectronics.com.

Viking K-2000-DVA Multi-Input Voice Dialer/Announcer Technical Information